Liên hệ: 08 399 30967 - 098 262 8117 - Nick Chat: minhnguyet2287 - Skype: minhnguyet2287 Description The Wildcard TDM2400P is a full-length PCI 2.2-compliant card that supports FXS and FXO station interfaces for connecting analog telephones and analog POTS lines through a PC. Using Digium's Asterisk Open Source PBX software and standard PC hardware, one can create a SOHO (Small Office Home Office) telephony environment that includes all the sophisticated features of a high-end business telephone system. The TDM2400P takes the place of an expensive channel bank and brings the system price point to a low level. By using X400M and S400M modules with the TDM2400P, one can create a solution with support for a range of telephones. To scale this solution, simply add additional TDM2400P cards populated with modules. Digium's TDM2400P range is available using the drop-down box below. The naming convention for this product is TDM24XYB/E: X — represents the number of FXS (analog telephone interface) modules installed. Each FXS module has four analog telephone ports. Y — represents the number of FXO (analog PSTN line interface) modules installed. Each FXO module has four analog PSTN line ports. B/E — represents the presence of the optional echo cancellation module. B indicates the board does not have hardware echo cancellation support, and E indicates the board does have hardware echo cancellation support. Note, however, that software echo cancellation can still be used. Unlike previous Digium boards which had RJ-11 or RJ-45 jacks on the back of the card, this card features a 25 pair (50 pin) "Amphenol" connector as shown in the picture above. If you are not familiar with this style of connector, the easiest way to connect to your new Digium board is using a patch panel with a 25-pair connector. Note: The Digum TDM2400P has a 12V power connector (like those used inside your PC's case for powering hard drives and CD-ROM drives), and this must be connected if you have FXS modules installed.